Suzuki Motorcycles Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I'll try and give as much detail as I can. About 3 months ago I had smoke come out of my left controls (turn signal, hi/low light switch etc.). Luckily I was close to home. Disconnected the battery immediately. The harness was fried. Bought another harness and after installing it everything seemed perfectly fine. I put probably 1000 miles on the bike in a couple months. Then one day omw home from work in a rain storm that harness just fried again. It was the same wire. Nothing else past where it connects to the main harness in the headlight is melted. Everything looks in tact.

When I took this one apart there was some water inside. So was this just an insane coincidence(I doubt it)? What would cause just that harness to melt but nothing else? I've Googled a lot but haven't found anything helpful. Seems weird that it was totally fine for so long and then just fried.

Thanks in advance for ANY help.
 
1 - 1 of 1 Posts
Top