Suzuki Motorcycles Forum banner
1 - 11 of 11 Posts

·
Registered
Joined
·
113 Posts
Discussion Starter · #1 ·
I need Yosh kit parts (and other race parts) for my '96 SRAD.

I am looking for

Yosh CDI
Yosh Tach
Yosh 4-1 exaust
Yosh Battery lead, for the kit harness
Yosh Kill switch
Superbike tail plastic
Yosh tripple clamps
Yosh clip-ons

I will update this first post as time goes on or need change.
 

·
Registered
Joined
·
113 Posts
Discussion Starter · #3 ·
Thanks! Can you delete that link? I am going to bid on it, and don't want any unneccessary compitition.
 

·
Registered
Joined
·
113 Posts
Discussion Starter · #7 ·
Old Skool_R said:
I figured you could buy the top tripple and then take it to a machinist and have him spin you up a lower.
I am a machinist. I would need to take many measurments off an original to do all the weight saving pockets and still have enough strength. I am not an engineer.

If I were going to design my own, they would be pretty heavy. But I could do it.
 

·
Registered
Joined
·
324 Posts
sqrly said:
I am a machinist. I would need to take many measurments off an original to do all the weight saving pockets and still have enough strength. I am not an engineer.

If I were going to design my own, they would be pretty heavy. But I could do it.
Why not just do a copy of the top clamp if you win it?
 

·
Registered
Joined
·
113 Posts
Discussion Starter · #9 ·
Old Skool_R said:
Why not just do a copy of the top clamp if you win it?
The lower clamp is designed different. It needs to be stronger than the top because the forces from leverage are much greater at the lower clamp than the top.
Sure, I can copy the positions of the steering shaft and the fork leg holes. But that doesn't help much, I need to know where and how big to make the weight saving pockets, so that I don't reduce the strength neccessary for it to do it's job.

My plan is if I can get a set of these, is to make a couple extra copys.
 
1 - 11 of 11 Posts
Top